Combines 1020 platform cutting poorly 1 1 2 inch cut

CJ

Guest
Tootall we had an inch and a half knife and could never get it to work right. I spent most of every morning adjusting it and still didn't get a good cut. We finally replaced it with a three inch cut and that improved it a lot but it still wasn;t 100% so we swithed to a Crarry GoldCut and it is just great, can cut soys at 7 to 8 miles an hour if you want and still have a very clean cut. It seems like a lot of money to replace it but it is well worth it. There is very little adjustment needed and every thing stays tight.
 

aaa

Guest
TOOTAll: I AGREE WITH C.J. A 3"CRARY SYSTEM WIll HElP YOU OUT A GREAT DEAl. I AlSO CUT EDIBlE BEANS AND FOUND TO GET lOWER TO SHAVE THE GROUND I HAD TO MODIFY MY 1020 HEAD.WHAT I DID WAS CUT 3_8" TO 1_2" OUT UNDER MY lONG ARMED SKID PADS AND FlATTENED THE SKID PAD DOWN AND WElDED IT TO THE ARM. I DID THIS TO All MY lONG ARMED SKID PADS AND THEN TOOK OFF All THE REST OF THE SKID PADS AND FlATTENED THEM TO lOOK ABOUT THE SAME. I DID NOT CUT THE DRIVE SIDE SKID.
 
 
Top