NDDan
Guest
If the header has a tee handle on right side of header in a hydraulic line you would have a so called torque limiter_slip clutch built into reel drive. If it has this you may want to turn it in. If it is turned in all the way and still won't hold torque you can remove it and plug the line (should never need to do that on a 20') removing and caping line will allow higher pressure than valve can be set for. Also check the brass inline check valve on right side. There could be something stuck in it allowing the oil to leak by when you are tring to run reel. The oil will normally run backwards threw this valve when header is not engaged. Good luck