Thread: wind problems

  1. #1
    Rig
    Guest
    I was at the AGCO plant the other day for a plant tour and product roll-out program. They talked about this problem as on-going with their new models that have the larger fan. A spokesman said they are working on the problem and it is JOB 1.

  2.  

  3. #2
    NDDan
    Guest
    They could perforate panel under header clutch shaft. This would help but I think ultimately they need more square inches of screen to such threw. I would lower down screen door 2 to 3" and then extend the screened material under clean grain and tailings augers. This would greatly reduce suction per square inch thus likely never get suched up tight with material.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in