Combines R65 not feeding

NDDan

Guest
We extend the flighting to prevent the void on tube. Material will just boil there and eventially block the flow up row five. Also the slope kit that protruds floor a couple inches into feeder help keep material flowing
 

l3

Guest
Added an extra half link to feed chain and that seemed to help a little. Flighting on this hugger head seems to about meet in the middle (on opposite sides). Do you extend it so it actually overlapsIJ Haven't ever seen the slope kit. This is on the headIJ There is quite a "dead area" in between there.
 

NDDan

Guest
Have not seen a hugger yet where flighting met on a center line. I would meet on centerline and protrude beyond center a bit. Maybe trim down flighting an inch where it overlaps the centerline. A one or two inch gap makes all the difference. The slope fastens right under auger and protrudes onto feeder floor a couple inches. You can easily make something like this and fasten in. I believe it can be found near the back of parts info if book is new enough.
 
 
Top