Auctionguyyy
Junior Member
- Messages
- 135
Having a problem getting my WM Drain software to calibrate with my new ditcher on my MX240
When I run the calibration process, it raises and lowers the ditcher as it should to the full range, which is about a foot, and then gives me an error message that it has insufficient travel to calibrate.
Anybody know a setting that I have wrong somehow?
Thanks in advance.
View attachment 377
When I run the calibration process, it raises and lowers the ditcher as it should to the full range, which is about a foot, and then gives me an error message that it has insufficient travel to calibrate.
Anybody know a setting that I have wrong somehow?
Thanks in advance.
View attachment 377