Combines rotor cone

John_W

Guest
Check out the cones from loewen. AR steel and various vane options. list of dealers at the bottom of page.
 

kbl

Guest
if you have gotten that many hours out of the first one why would you consider anything but oemIJ
 

JWK

Guest
If you look behind the seams of the rotor cone you may see some extra wear from the hour usage. I have removed the rotor and welded up the "cupped" area be these seams, I think there are 3 of them. On the left side, or where the crop is pushed up more vertical, it will show more wear in the steel. Welding will burn off the nice paint outside the cone and make sure that no hoses are in that area. Useing a wire feed welder is best for this. JWK
 
 
Top