tbran
Guest
have you calabrated per op manIJ There are potentiometers on each side , there must be a balalnced voltage to work properly. 5V goes down and 1.5 to 4 should be returned.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines auto header control question
posum
Guest
Yes have calibrated.all the way up press C; all the way down press l--IJ. It works fine sometimes sometimes does not; maybe a shorted wire or somethingIJ
Rolf
Guest
Check wire near the feeder house pivot! they can get stretched there sometimes and we had intermittent trouble as well on ours till I found the wire at the feeder pivot on cab door side up under neath was a bit stretched for some reason and it had a break in there! Rolf
Gleamer
Guest
I had an issue with lateral tilt I thought. The three wire connector at the feederhouse had one of the wires pushing out the back of the socket that holds them. Make sure all connections are getting voltage thru the blocks they are held in. Good luck, Thanks to tbran for his help.....