NDDan
Guest
Set sender gap close as possible and roll over by hand to check all legs. Beeper will only go on for about six beaps than just light will stay on. So you have feeder on fastIJ Otherwise check sender with ohmeter and compare with working sender. If sender checks out go to plug in side counsel and with wireing schematic find the same two wires to check again. Then go to wires where module plugs in. If good reading all the way to module you might need to have module checked out. There are tweaker screws on side of module to set where you want light to go out at. For feeder I would have corn varible slowed all the way and chain on slow speed position then set light to go out at 1800-2000 engine RPM. Not to much to worry about that light because if it does slow down much your feeder clutch will likely let you know about as quick as light. Good luck