Combines Moisture reading

land_Surfer

Guest
The plunger attached to the moisture sensors used for cleaning out the chamber after each reading might be stuck in the down position. Make sure that you clean this sensor out daily. What I have had happen to mine is that sometimes grain or debris can get behind the plunger and wedge it in the chamber. No real good way to cover it, just keep in cleaned off. Also, make sure that the brass set screw on the end of the solenoid next to the sensor is screwed all the way out to allow for max pressure to push the plunger up. With the engine running, you can actually operate the plunger by turning in and out this screw. Also, whenever you switch off the separator, the plunger should cycle.
 

2rotorsrule

Guest
Thanks, I'll take a look. I'll post more if I still can't get it.
 
 
Top