Rusty
Guest
I still think you may have a sensor problem. If you are swapping the tailings for the shoe sensor your monitor is "seeing" a different type of sensor. Try swapping the clean grain and tailings sensors. If your problem switches to a open clean grain sensor there's your problem. Or do you have access to a new sensor to try. If all this fails try doing a continuity check with an ohmeter at the connector going into your tractor. You will need a 1682 electrical schematic. I know these can be tricky. Of all of the sevice work I've done on pull type combines the electrical is by far the largest percentage of that. You can't get a more mechanically simple combine. Good luck.