Combines afs

[STATIC_84]

Also check your header stop height, so that has not been changed or goofed up. you could then go to a new fieldandload, lower the header engage sep and fdr drive around the yard, then take your to desk top and see if mapped! Oh you can first tell the monitor "to map without crop flow"

 

[boog]

ED, Are you referring to the acres showing on the summaryIJ We are running the the 2000 version with updates in 2003 and it does not show acres on the map legend. The difference between recorded acres and actual field acres can be several things. Such as error in calibration, taking less than a full swath with a platform ( we set ours for 1.5 ft less than actual header width),setting to turn on and off recording is set to high or you are lifting or header late or dropping it earlier. Mainly the reason is that if you are using actual FSA acres they tend to be wrong. There also ar a lot of glitches in the software and it is very user unfriendly. The new software out this year is by Ag lleader and is suppose to have a lot of improvements and a lot more user friendly. However, CIH is quite proud of it and wants $350 to upgrade.

 

[trapper219]

One of the acres that you see should match what your monitor says. The other acre count is derived from processing the "filtered" data and will be less than the yield monitor data, because the software filters out some data points that it deems incorrect, and then generates area based on the remaining data points. Make senseIJ I bet you'll find two different yield numbers too, one matching the monitor and one that is calculated from the filtered data.

 

[Case_Farmer]

So you want to go into your desktop and take the data card and load it into your desktop software. After you do that Hollar at me Cause from there you create a data card for your combine