Dan
Guest
Has header opening been properly narrowed for R52. Tall flighting on auger should be extended to bring straw into area just ahead of feed chain. Stripper behind auger gets extended to edge of feeder opening. Be sure there are no sharp corners or edges protruding where flighting or stripper is extended. Header opening should be as wide as feeder unless you are in straw that likes to wrap up on driveshafts and then you would narrow header opening. There should be about four of the far right fingers removed from header auger. Area under fingers should be smooth and not all rusted up. Filler between header and feeder should be slid back to prevent the hole inbetween header auger and feeder. Knock the filler down if needed to get a smooth floor inbetween header and feeder. Do you have feeder shocks installed and front drum in grain front positionIJ