Combines 8570 Constant speed RotorIJ

[northernfarmer]

Joe: where are you locatedIJ If I can do it anyone can. You need just basic tools and some wire connectors...I'll help you out if you decide to go ahead with putting a constant speed control on your 8570...Email me at: nlegaarden@sasktel.net

 

[JJS]

I am located in Southern Michigan close to the IN, and OH borders . And I would like to put the constant speed on this machine. I probly wouldn't do it this year, (too close to harvesrt),I still have to go over the machine , and set it up. Also have to transfer the RWA from the 860 to the 8570. About how much time does it take to do the modIJ Thanks. Joe

 

[northernfarmer]

Joe: getting the kit from your massey dealer will take the time, takes a week to get a kit from Massey, unless Your dealer stocks them(not likely) to install it doesn't take long at all, a couple of hours and very easy. There is some things that have to be done before hand...Send me an email, include your phone n and best time to call, and I'll explain everything to you.......Neil

 

[JJS]

How do I get your EmailIJ Joe

 

[Countryboy]

Will this kit work for an 8560IJ

 

[swtvid]

Neil I have bing thinking about the sender wheel on front of rotor, it may simplify it a little more if it where posible to get holes cut in the sender wheel like the old one has(slitely in to the center) then stack the sender on the same mout that is there. Dee mellowc@plmw.com if JJS needs Me Neil has every thing doctumented regood.

 

[swtvid]

Neil I have bing thinking about the sender wheel on front of rotor, it may simplify it a little more if it where posible to get holes cut in the sender wheel like the old one has(slitely in to the center) then stack the sender on the same mout that is there. Dee mellowc@plmw.com if JJS needs Me Neil has every thing doctumented regood.

 

[swtvid]

I dont know never seen the 8560, I was told it only used one charge pump for both rotor and machine drive. If it uses sandstrum 90 series 100cc pump and motor it may work. Neil has run the 8560 I thing he will know. Dee

 

[northernfarmer]

joe it is in my first reply to your first post...nlegaarden@sasktel.net

 

[northernfarmer]

countryboy, first thing checkout about the pump like Dee suggests...I don't think it will work, or should I say install as easy as on an 8570. the rotor speed control in the 8560 is different than in an 8570....if You could get Dee the wiring diagram of an 8560's rotor control he could tell you if it can be done...Neil